I could be wrong, but maybe its because the 215 only has one interface. Do you have any 225s or other 2 interface APs you could add in its place and see if the LAGs start working again?
------------------------------
Dustin Burns
Senior Mobility and Access Engineer @WEI
ACCX 1271| ACMX 509| ACSP | ACDA | MVP Guru 2021
If my post was useful accept solution and/or give kudos
------------------------------
Original Message:
Sent: May 20, 2021 04:19 AM
From: Karl Aspinall
Subject: IAP-225 LAG Failed when se to Preferred Master
Hello,
Here is the the out put;
I noticed that the LAG was okay until the IAP215 joined, then this.
------------------------------
Karl Aspinall
Original Message:
Sent: May 08, 2021 08:48 AM
From: Karl Aspinall
Subject: IAP-225 LAG Failed when se to Preferred Master
Hello,
Looking for some answers, I have two IAP's one is 225 the other is 215, the cluster sets the preferred master to 215 I tried to set the 225 as the preferred master but the LAG fails and only one port remains active.
I switch off the preferred master and the master goes back to 215 and the LAG on the 225 is restored.
The firmware running is;
8.6.0.2_73853 (Digitally Signed - Production Build)
Thank you for any help.
Karl
------------------------------
Karl Aspinall
------------------------------