I'm going to answer my own question regarding which controller i choses on apboot, it's the controller you have specified under your ap-group and then under ap-system-profile.
Question remains though if it always reboot's when using ap-move or not?
------------------------------
Grex Free
------------------------------
Original Message:
Sent: Sep 01, 2021 03:12 AM
From: Grex Free
Subject: Apboot during update
Looking to update our environment of controllers and access points, the below is just a simplicity of my question, thanks for any help!
Say that you have a primary controller with ip (Switch IP) 1.1.1.1 a redundant secondary controller with ip (Standby IP) 2.2.2.2.
We start by moving all access points from 2.2.2.2 to 1.1.1.1 with ap-move all, we then update our standby controller.
When this is done we want to boot / move back and update all access points, we do this with apboot all, does this update and move them back to 2.2.2.2 (the other controller)?
If we use ap-move all do the move / reboot to 2.2.2.2 and update?
Can you use apboot on controller2 on five access points say in group A so they get on controller1 and update -
and then from controller2 issue apboot ap-group A and only the remaining access points on controller2 will boot and update to controller1 (not the one already updated beforehand, these on controller1 will not reboot), correct - right?