For an IAP, the switch configuration would be defined as a trunk port. The untagged VLAN would be the IAPs management VLAN (where the IAP obtains an IP address for management) and the tagged VLANs would be your client VLANs.
e.g
VLAN10 = Untagged = IAP Mgmt
VLAN20 = Tagged = Corporate WLAN
VLAN30 = Tagged = Guest WLAN
------------------------------
Craig Syme
------------------------------
Original Message:
Sent: Oct 29, 2020 01:05 PM
From: Sayan Roy Chowdhury
Subject: IAP Configuration
Hi everyone,
Could any one help me with the steps, not any VRD or guide, to setup an IAP with the switch.
What port configuration should be done in the switch. if the AP is currently working as an RAP and i want to make it an IAP for temporary time with initial configuration and provisioning steps.
Thank you
------------------------------
joxor
------------------------------