If you mean the 2930F (I don't know a 2960F), you can use the 'ip ssh port' command:
sw00(config)# ip ssh
cipher Specify a cipher to enable/disable.
filetransfer Enable/disable secure file transfer capability.
mac Specify a mac to enable/disable.
port Specify the TCP port on which the daemon should listen for SSH connections.
public-key Configure a client public-key.
rekey Enable SSH key re-exchange.
timeout Specify the maximum length of time (seconds) permitted for protocol negotiation and authentication.
<cr>
sw00(config)# ip ssh port
default Specify that the daemon should listen on the default TCP port (22).
TCP/UDP-PORT Specify the TCP port number on which the daemon should listen.
------------------------------
Herman Robers
------------------------
If you have urgent issues, always contact your Aruba partner, distributor, or Aruba TAC Support. Check
https://www.arubanetworks.com/support-services/contact-support/ for how to contact Aruba TAC. Any opinions expressed here are solely my own and not necessarily that of Hewlett Packard Enterprise or Aruba Networks.
In case your problem is solved, please invest the time to post a follow-up with the information on how you solved it. Others can benefit from that.
------------------------------
Original Message:
Sent: May 26, 2021 08:17 AM
From: Norbert Joseph Quezon
Subject: How to change SSH port number from 22 to any non-reserved port number
Hi All,
I just want to ask how to change the SSH port number from the default number 22 to a non-reserved port number on Aruba 2960F? Thanks!