I have imported the MIB to IMC, seems like most of the commands are working. Two things I noticed:
01 - When I open the switch device panel, it shows me a generic port layout, not the switch image. I belive that's because the switch isn't supported.
02 - Using the Network Topology map, we can change the vlans on the switch ports, but we can't add new vlans to rhe switch from it. the error message when we try to do this says it's an SNMP error, but other SNMP commands are working fine. Could this be a problem when we imported the MIBs or just a SNMP command the switch doesn't have?
Error steps would be as follows:
01 - open the network topology;
02 - open the vlan view;
03 - Select any vlan not currenctly on the switch;
04 - Select said vlan and right click on the Aruba switch;
05 - Select Add to current Vlan
06 - The message "Failure SNMP operation failed. Please check the device's configuration" appears.
is this error logged somewhere?