I'm trying to deliver 802.3 at power to my Aruba AP-515 (Instant Access Points)
My old school switch, 5406ZL switch delivers 802.3 af
I upgraded one of the PoE modules which now supports 802.3 at. Then changed the port 'AllocateBy: usage' 'set value to 33 W' and bingo! it works.
I then upgraded the firmware on the 5406ZL switch from v15 to v16. In doing so the power negotiation has reverted back to 'af' for said port, WIFI access points are now offline...
Whatever I try, GUI or CLI I cannot change the AllocateBy from LLDP to Usage. (assuming 'Usage' would fix it)
If I physically remove the access point from the switch the port changes back to usage. When I plug the device back in again it changes to LLDP.
I'm totally stuck, I don't know what to do. Thanks for any help with this.
At Aruba, we believe that the most dynamic customer experiences happen at the Edge. Our mission is to deliver innovative solutions that harness data at the Edge to drive powerful business outcomes.
© Copyright 2021 Hewlett Packard Enterprise Development LPAll Rights Reserved.