I believe you need to have a gateway in your group and have the basics configured.
So I suggest that you get your BGW up and running by configuring the system IP, and relevant VLAN for WAN/LAN and then enable IGMP on your VLANs.
------------------------------
Any opinions expressed here are solely my own and not necessarily that of Hewlett Packard Enterprise or Aruba.
------------------------------
Original Message:
Sent: Sep 14, 2021 05:10 AM
From: Chris Denham
Subject: Branch Gateway IGMP Querier?
Hmmm I'm also in apac-south1 - if you create a test BGW without any other config do you get that option? (e.g. for VLAN 1)?
------------------------------
Chris Denham
Original Message:
Sent: Sep 14, 2021 04:24 AM
From: Ariya Parsamanesh
Subject: Branch Gateway IGMP Querier?
mine is in APAC-South1
------------------------------
Any opinions expressed here are solely my own and not necessarily that of Hewlett Packard Enterprise or Aruba.
Original Message:
Sent: Sep 14, 2021 03:29 AM
From: Chris Denham
Subject: Branch Gateway IGMP Querier?
That is very strange - I don't have that option, what Central region are you in?
------------------------------
Chris Denham
Original Message:
Sent: Sep 14, 2021 03:03 AM
From: Ariya Parsamanesh
Subject: Branch Gateway IGMP Querier?
yes branch gateways support enabling IGMP.
See this screenshot from the group level configuration
------------------------------
Any opinions expressed here are solely my own and not necessarily that of Hewlett Packard Enterprise or Aruba.
Original Message:
Sent: Sep 13, 2021 07:06 PM
From: Chris Denham
Subject: Branch Gateway IGMP Querier?
Does anyone know if it is possible to enable IP IGMP on a L3 interface of a Branch Gateway to facilitate IGMP snooping for a downstream L2 switch?
The only option I can find is 'broadcast multicast optimization' on the VLAN configuration, but this doesn't seem to enable the querier.
------------------------------
Chris Denham
------------------------------