Wireless Access

 View Only
last person joined: yesterday 

Access network design for branch, remote, outdoor and campus locations with Aruba access points, and mobility controllers.
Expand all | Collapse all

IAP vpn to Virtual GW

This thread has been viewed 12 times
  • 1.  IAP vpn to Virtual GW

    Posted Jan 24, 2022 05:30 AM

    I have configured a L2 centralized IAP vpn tunnel to a Virtual gateway.

    I can see that ISAKMP and IPSec is up between the AP en the gateway.
    But the configured vlan interface is not offered to the tunnel.

    "show iap table" shows only the mac address and that its up. Nothing at vlan assignment.

    I have configured the vlan interface on the gateway and as L2 centralized on the IAP.
    IAP has its def gw to the vlan interface on the gateway.

    Any ideas what to look for?


  • 2.  RE: IAP vpn to Virtual GW

    Posted Jan 24, 2022 03:01 PM
    What the configuration on IAP ?

    do you have check the log ?

    what firmware release ?

    PowerArubaSW : Powershell Module to use Aruba Switch API for Vlan, VlanPorts, LACP, LLDP...

    PowerArubaCP: Powershell Module to use ClearPass API (create NAD, Guest...)

    PowerArubaCL: Powershell Module to use Aruba Central

    PowerArubaCX: Powershell Module to use ArubaCX API (get interface/vlan/ports info)..

    ACEP / ACMX #107 / ACDX #1281

  • 3.  RE: IAP vpn to Virtual GW

    Posted Jan 27, 2022 10:47 AM
    I removed the radius proxy and the virtual controller netmask, gateway and vlan. 
    Then it started working.

    But the thing is that I have these settings in an old setup to be able to use radius proxy over vpn.

    Jonas Wennergren