Wireless Access

 View Only
last person joined: 3 days ago 

Access network design for branch, remote, outdoor and campus locations with Aruba access points, and mobility controllers.
Expand all | Collapse all

WLC "up" , "CONFIG ROLLBACK" then WLC "down", "UPDATE REQUIRED"

This thread has been viewed 10 times
  • 1.  WLC "up" , "CONFIG ROLLBACK" then WLC "down", "UPDATE REQUIRED"

    MVP
    Posted Jan 26, 2022 01:33 AM
    Local WLC continuously reboots itself , on mobility manager it is firstly shown for this WLC:
    WLC "up" , "CONFIG ROLLBACK" , then in several seconds WLC "down", "UPDATE REQUIRED".
    I assume this loops happens when old new config is replaced by old config locally on WLC or from mobility master. How can I stop such replacement and cut this loop of reboot?!


  • 2.  RE: WLC "up" , "CONFIG ROLLBACK" then WLC "down", "UPDATE REQUIRED"

    MVP GURU
    Posted Jan 26, 2022 08:06 AM
    Take a look at the interface configuration, and the shared secret config between MC/MM and make sure it matches. Might need to take down the uplink to the controller and do this over console. See if the interface settings match. I usually see this issue when the MM pushes the wrong port config down, and the controller can not reach the MM anymore.

    ------------------------------
    Dustin Burns

    Lead Mobility Engineer @Worldcom Exchange, Inc.

    ACCX 1271| ACMX 509| ACSP | ACDA | MVP Guru 2022
    If my post was useful accept solution and/or give kudos
    ------------------------------