Hello,
I'm currently searching for a way to actively do SNMP get the status of LACP and VRRP of the 8.6 version of the controllers.
Example, if we do the 'show vrrp' command, we will get the following output:
Virtual Router 220:
Description Primary MM
Admin State UP, VR State MASTER
IP Address 10.200.20.1, MAC Address x, vlan 1
Priority 200, Advertisement 3 sec, Preemption Disable Delay 0
Auth type PASSWORD, Auth data: ********
tracking is not enabled
The state is 'Master' but I'm unable to find an SNMP GET that polls this information. I would like a notification when the status changes to 'Backup'
The same goes for LACP:
Flags: S - Device is requesting slow LACPDUs
F - Device is requesting fast LACPDUs
A - Device is in Active mode P - Device is in Passive mode
LACP Internal Table
-------------------
Port Flags Pri AdminKey OperKey State Num Status
---- ----- --- -------- ------- ----- --- ------
GE 0/0/2 SA 255 0x2 0x2 0x3d 0x3 up
GE 0/0/3 SA 255 0x2 0x2 0x3d 0x4 up
Can I somehow poll those flags? I would like to get a notification if the flag changes to Passive mode.
Best regards