Wireless Access

 View Only
last person joined: 20 hours ago 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

Question About AP-Groups with Different Types of APs

This thread has been viewed 8 times

  • 1.  Question About AP-Groups with Different Types of APs

    Posted Jun 16, 2021 02:30 PM
    We are on the verge of transferring from a 6.5 master-local controller setup to an 8.7 Mobility Master setup and had a question about AP groups. On 6.x, We needed to have separate AP groups for 303H and 315 because of the wired ports on the 303Hs. On 8.x, I tried placing these 2 APs in the same AP group with the wired ports enabled and configured. Both APs worked properly without any visible issue, but I wanted to verify that this won't cause an issue.

    ------------------------------
    NOC Manhattan College
    ------------------------------


  • 2.  RE: Question About AP-Groups with Different Types of APs
    Best Answer

    EMPLOYEE
    Posted Jun 16, 2021 03:08 PM
    You will be fine.  If an AP does not have a second ethernet interface, the configuration will be ignored.

    ------------------------------
    Any opinions expressed here are solely my own and not necessarily that of Hewlett Packard Enterprise or Aruba Networks.
    ------------------------------

    Original Message