Wireless Access

 View Only
last person joined: yesterday 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

Cisco 9200L native vlan to AP 514

This thread has been viewed 8 times

  • 1.  Cisco 9200L native vlan to AP 514

    Posted Mar 24, 2021 12:55 PM
    Hi all,

    I wonder if anybody can help with the problem below.
    I have switch stack Cisco 9200L FW 16.12.4
    Aruba AP FW 8.7.1.2_79305
    There are several Aruba 514 APs connected to the switch stack.
    The ports configured the following way:
    desc WAP
    switchport mode access
    switchport acc vl 2309

    The APs chose the Virtual controller. And I can see them all through it.
    I've changed Uplink switch native VLAN to 2309 in System -> General
    I assume this should populate the config to all APs.
    However if I change the switch port configuration to the following - I cannot connect to APs and the APs are unable to obtain IP from the DHCP.
    Switchport mode trunk
    switch pot trunk native vlan 2309
    switchport trunk allowed vlan 2310-2312

    It looks like the native VLAN wasn't changed on APs.
    Kindly help me to find the missing piece here.​​

    ------------------------------
    asd asd
    ------------------------------


  • 2.  RE: Cisco 9200L native vlan to AP 514

    Posted Mar 24, 2021 09:27 PM
    Resolved.
    switchport trunk allowed vlan 2309-2312

    ------------------------------
    asd asd
    ------------------------------

    Original Message