Hello,
we will replace our Comware switches with Arube CX. I have a couple of configuration questions.
1. Do we have to enter data for IPv6 or we can ignore it if IPv6 is not used?
2. When is a port set to "no shutdown"?
3. When is a port set to "no routing"?
4. With which command you can configure the following?
- gvrp enable
- burst-mode enable
- stp bpdu-protection enable
- stp edged-port enable
- stp enable (I think it is default enabled)
5. LACP Configuration
Comware
interface Bridge-Aggregation1
port link-type trunk
port trunk permit vlan all
link-aggregation mode dynamic
interface GigabitEthernet1/0/45
port link-type trunk
port trunk permit vlan all
port link-aggregation group 1
interface GigabitEthernet1/0/46
port link-type trunk
port trunk permit vlan all
port link-aggregation group 1
Arube (I'm not sure if this configuration is correct?
switch# config
switch(config)# interface lag 1
switch(config-lag-if)# no shutdown
switch(config-lag-if)# lacp mode active
switch(config-lag-if)# vlan trunk allowed all
switch(config-lag-if)# interface 1/1/45
switch(config-if)# no shutdown
switch(config-if)# lag 1
switch(config-if)# interface 1/1/46
switch(config-if)# no shutdown
switch(config-if)# lag 1
We'll get the new switches in a couple of weeks and I'm just getting used to the configuration.
However, we will not immediately replace all the switches at once, we will gradually replace them.
thanks
Marcel
------------------------------
Marcel Mai
------------------------------