Need some help, anyone having the cable setup diagram for the AP-CBL-SER cable. Expensive to purchase from Aruba.
You cannot build that cable. Please look at the thread here: http://community.arubanetworks.com/t5/Aruba-Instant-Cloud-Wi-Fi/Pinout-serial-for-RAP-155P/m-p/167288/highlight/true#M5851
You will have to purchase it.
Thanks, didn;t know it is active instead of passive equipment.
Or, you can do as i did. I had to access the serial on an AP103 and could not get a hold of the propper console cable at the moment. I searched the Airheads community and with the info i could find i sucessfully managed to access the console using a cheap USB-TTL converter i had at home:http://www.ebay.com/itm/FTDI-FT232RL-USB-to-TTL-Serial-Converter-Adapter-Module-5V-3-3V-for-Arduino-/321875438143?hash=item4af1456a3f
USE AT OWN RISK!
I do not guarantee this will work, if done wrong there is a risk that you permanently damage the console port of your AP/RAP!
First set the jumper on the USB-TTL converter to 3.3V! (5V TX signals might damage the console port on the AP/RAP, i have not tested 5V since 3.3V works.)
Secondly connect cables like this:
That's it. TTL-USB converters are not really rocket sience, and the Arduiono boom have made the converters really cheap and easy to find.
As Tamaz cited, you can use a USB TTL adapter, but you can also use a standard TTL-RS232 adapter as well.
It appears that the PIN out is also the same, VCC, RX, TX, and Ground.
VCC on the RAP-3 and the AP-205H appears to be 3.3V.
Can be found here:
At Aruba, we believe that the most dynamic customer experiences happen at the Edge. Our mission is to deliver innovative solutions that harness data at the Edge to drive powerful business outcomes.
© Copyright 2021 Hewlett Packard Enterprise Development LPAll Rights Reserved.