Higher Education

Good afternoon 

Based on the RAP documentation do we cluster the controllers the same way clustering mobility controllers but instead of using private addresses I can use public addresses to avoid dealing with one to one NAT at the firewall. So, if I have 2 controllers I will need 4 IP addresses. One for management controller-ip and one for CoA for clearpass in the cluster profile. Also, I need to make sure I create the VLAN pool name at the Master level then configure the ip interface locally at the mobility device level. Am I on the right track? 


Thank you for the time, 
Nils

------------------------------
Nils Lau
Nova Southeastern University
------------------------------

It sounds like you're on the right path here.

Are you proposing to use public IP addresses as controller-ip and COA? You would typically have a cluster Virtual IP address also.
Original Message:
Sent: Oct 18, 2021 01:54 PM
From: Nils Lau
Subject: Remote AP Cluster in Aruba 8

Good afternoon 

Based on the RAP documentation do we cluster the controllers the same way clustering mobility controllers but instead of using private addresses I can use public addresses to avoid dealing with one to one NAT at the firewall. So, if I have 2 controllers I will need 4 IP addresses. One for management controller-ip and one for CoA for clearpass in the cluster profile. Also, I need to make sure I create the VLAN pool name at the Master level then configure the ip interface locally at the mobility device level. Am I on the right track? 


Thank you for the time, 
Nils

------------------------------
Nils Lau
Nova Southeastern University
------------------------------

Original Message:
Sent: 10/19/2021 8:17:00 AM
From: ProbeRequest
Subject: RE: Remote AP Cluster in Aruba 8

It sounds like you're on the right path here.

Are you proposing to use public IP addresses as controller-ip and COA? You would typically have a cluster Virtual IP address also.
Original Message:
Sent: Oct 18, 2021 01:54 PM
From: Nils Lau
Subject: Remote AP Cluster in Aruba 8

Good afternoon 

Based on the RAP documentation do we cluster the controllers the same way clustering mobility controllers but instead of using private addresses I can use public addresses to avoid dealing with one to one NAT at the firewall. So, if I have 2 controllers I will need 4 IP addresses. One for management controller-ip and one for CoA for clearpass in the cluster profile. Also, I need to make sure I create the VLAN pool name at the Master level then configure the ip interface locally at the mobility device level. Am I on the right track? 


Thank you for the time, 
Nils

------------------------------
Nils Lau
Nova Southeastern University
------------------------------