The difference between the 303H and 303HR is that the HR comes as a remote AP version with a desk stand attached:
Aruba AP-303HR (EU) 802.11ac Dual 2x2:2 Radio Remote AP Bundle. Contains AP-303H (RW), desk stand (assembled, attached), RJ45 jumper cable (installed), power adapter European AC power cord (europlug)
(taken from the data-sheet)
By just taking off the desk stand, you can convert an 303HR into an 303H. The AP itself is identical and can be used with Aruba Instant or as a controlled AP (Campus AP or Remote AP). To get the AP into Instant mode, make sure it is not managed through Central or Activate by a previous owner, then hold the reset button (use a paperclip to reach the button behind the reset hole) while powering on the AP, when the LEDs start flashing release the reset button. The AP should come up as Instant AP after that, which may take 5-15 minutes the first time after the reset.
In the topic you mentioned InstantOn, but that is a completely different product line and it is not possible to run InstantOn on other APs than dedicated InstantOn.
------------------------------
Herman Robers
------------------------
If you have urgent issues, always contact your Aruba partner, distributor or Aruba TAC Support. Check
https://www.arubanetworks.com/support-services/contact-support/ for how to contact Aruba TAC.
------------------------------
Original Message:
Sent: Nov 25, 2020 03:38 PM
From: Max Unknowski
Subject: AP-303HR to AP-303H ( InstantOn )
Hi @ll
Is it possible to convert 303HR to Standalone 300H Instant AP
Can this be done without controller ?, over console cable USB ?
Thx
------------------------------
Max
------------------------------