Wired Intelligent Edge

 View Only
Back to discussions
Expand all | Collapse all

2626 J4900b Reset no response

This thread has been viewed 0 times

  • 1.  2626 J4900b Reset no response

    Posted May 31, 2014 03:15 AM

    Hi all,

     

    I've just reset my Procurve 2626 J4900b and now I can't get anything out of it?

     

    It reboots fine, and the lights indicate it's going through it's POST cycle, but after that, I've got no management interfaces?

     

    I held down the RESET + CLEAR buttons as per the manual and then released the CLEAR as the Self Test started blinking. That caused it to do the reset and POST... but now I can't get any management info out of it?

     

    I've tried connecting to the Console, nothing?!

    I've tested that cable on another switch and it's fine.

    9600, 8 data, 1 stop, no parity, Xon/Xoff 

     

    I've looked in the manual and even tried the Upload firmware steps if corruption is suspected. (no flow control)

     

    I can't work out what is going on? 

    Would the Management Web interface be up? 

    If so, what is the default IP address of the switch post config reset?

     


    #J4900b
    #Default
    #clear
    #2626
    #reset
    #firmware


Related Content