Hi all,
I'm working on some aruba gear and try to figure something out with NAT. It is long ago that I did some NAT configuration, however this was not with Aruba gear.
The topology is as followed:
The modem is from my ISP it does NAT and DHCP, but I want to put this in bridge mode and use the 2930f as NAT router. However, as I already read, the 2930f is a L3 swich and does not provide NAT functionality.
I did some research how to solve this, but I do not know what is wise.
1) Use the Branch Controller 7005 as NAT device. Than I need to connect the modem to the branch controller and the branch controller to the 2930f. However, is it good to move the Branch Controller to the edge?
2) Use the same topology as seen in the picture, and install on the NUC Sophos XG Firewall Home Edition. This should be a firewall and able to handle NAT(?), I don't have any experiences with this. However, I never configured a FW as a virtual server on the L3 SW. Normally the FW should be between the ISP and the L3 SW.
What are your ideas?
#2530#7005#2930F