Question on this statement:
"If there are applicable firmware updates in the new software image, they will be applied during the boot process as long as the timer has not yet expired; if there are no applicable firmware updates or if the timer has expired, the switch will boot normally."Is there a way to check on the progress of the firmware updates during the timer window? If we apply the command - "allow-unsafe-updates" (for, say, 30 minutes) and then proceed with the usual automated "vsx update-software" and there aren't any firmware updates will the system wait for the timer to expire before moving on to the updates (ie: we added 30 extra minutes to our window for no reason PER switch - presuming primary and secondary are updated sequentially.Is there a way to shorten the timer window interactive if there's no firmware updates being applied via show events -a -d hpe-isp?So if we set the timer for 30 windows, run the process and check show events after 5 minutes and see nothing happening, go back and change the timer to 1 minute to speed up the process?
© Copyright 2023 Hewlett Packard Enterprise Development LPAll Rights Reserved.