Hi all,
I have 2 x 8320’s and have one interface of each going into a firewall.
I’ve created a transit VLAN on each 8320 (vsx-sync) and have a gateway of .1
I’ve added OSPF info on this VLAN and it is peering fine from one of my 8320’s ... problem is when I disconnect this 8320 from the firewall (to test it automatically starts peering with the other 8320) - the OSPF state just stays in the ‘INIT’ state.
It always was in the INIT state but I presumed this was because the other 8320 had already formed adjacency ...
How can I set this to automatically fail over to the other 8320 in the event of a failure?
The OSPF is set to point-to-point if that makes any difference?
Thanks