SD-WAN

 View Only
last person joined: yesterday 

Forum to discuss HPE Aruba EdgeConnect SD-WAN and SD-Branch solutions. This includes SD-WAN Orchestration WAN edge network functions - routing, security, zone-based firewall, segmentation and WAN optimization, micro-branch solutions, best practics, and third-party integrations. All things SD-WAN!
Back to discussions
Expand all | Collapse all

9004-LTE wan redundancy not working

This thread has been viewed 20 times

  • 1.  9004-LTE wan redundancy not working

    Posted Jun 09, 2022 11:28 AM
    Hi,

    I've got a couple of gateways at a site and have WAN Redundancy configure but it's not working.

    Gateways: 9004 & 9004-LTE

    The non LTE gateway has an active WAN uplink but the LTE gateway never appears to establish connectivity to the shared WAN uplink.

    #show branch-gateway-peer counters

    IP Address of Transit VLAN in Peer: peer-IP
    Transit VLAN Interface: vlan-id
    Transit VLAN ip: local-IP
    Peer Mac Address: mac-address
    Peer Serial: blahblah

    Uplinks Sync Request Tx: 1
    Uplinks Sync Response Rx: 1
    Uplinks Sync Request Rx: 1
    Uplinks Sync Response Tx: 1

    Heartbeat Request Tx: 14
    Heartbeat Response Rx: 14
    Heartbeat Request Rx: 14
    Heartbeat Response Tx: 14

    Uplinks Sync (30 sec): Complete (Last Sync: Thu Jun 9 16:08:19 2022) <- this seems good right?
    Heartbeat (60 sec): Running (Last Heartbeat: Thu Jun 9 16:21:21 2022)

    But when I check the uplink on the LTE gateway:

    #show uplink

    Uplink Manager: Enabled
    Uplink Health-check: Enabled FQDN: pqm.arubanetworks.com(1.1.1.1 : Retrying Resolution)
    Uplink Load-balancing:Enabled Mode: Round-robin

    Uplink Management Table
    -----------------------
    Uplink Type Properties Uplink-id State Gateway Reachability WAN Type Speed Weight B/w utiln Max b/w
    ----------- ---------- --------- ----- ------- ------------ -------- ----- ------ --------- -------
    Wired vlan 4093 mpls Waiting for link -- Not Established MPLS 0 Mbps 10 0.00% 0%

    Any ideas?

    There are no firewalls between the gateways on the VLAN used for WAN redundancy.

    ​


  • 2.  RE: 9004-LTE wan redundancy not working

    EMPLOYEE
    Posted Jun 09, 2022 08:50 PM
    make sure VLAN 4093 is not configured on any interface marked as WAN in the other BGW

    ------------------------------
    Any opinions expressed here are solely my own and not necessarily that of Hewlett Packard Enterprise or Aruba.
    ------------------------------

    Original Message


  • 3.  RE: 9004-LTE wan redundancy not working

    Posted Jun 10, 2022 03:44 AM
    It's not configured on any ports marked as WAN port. In fact there are no port set as type WAN.
    Original Message