Hello
Please check in interface context the command speed auto . After auto you have the options to specify the max speed.
Here an example, it is not exactly 6100 but a 6000, I think it should be similar.
switch(config-if)# speed auto ?
100g Allow interface to link at 100Gbps
100m Allow interface to link at 100Mbps
10g Allow interface to link at 10Gbps
10m Allow interface to link at 10Mbps
1g Allow interface to link at 1Gbps
2.5g Allow interface to link at 2.5Gbps
25g Allow interface to link at 25Gbps
40g Allow interface to link at 40Gbps
50g Allow interface to link at 50Gbps
5g Allow interface to link at 5Gbps
<cr>
switch(config-if)# speed auto 100m
switch(config-if)# show run current-context
interface 1/1/1
no shutdown
speed auto 100m
vlan access 1
exit
switch(config-if)# speed auto 100m ?
100g Allow interface to link at 100Gbps
10g Allow interface to link at 10Gbps
10m Allow interface to link at 10Mbps
1g Allow interface to link at 1Gbps
2.5g Allow interface to link at 2.5Gbps
25g Allow interface to link at 25Gbps
40g Allow interface to link at 40Gbps
50g Allow interface to link at 50Gbps
5g Allow interface to link at 5Gbps
<cr>
switch(config-if)# speed auto 100m 10m
switch(config-if)# show run current-context
interface 1/1/1
no shutdown
speed auto 10m 100m
vlan access 1
exit
Original Message:
Sent: Aug 11, 2022 07:23 AM
From: Stephen Elliott
Subject: AOS-CX - Auto Duplex, Max Speed
Hi,
Is there any way to implement interface max auto-negotiate speed while maintaining auto-duplex on the AOS-CX range? (6100 specifically)
Similar to "speed-duplex auto-10-100" on the Aruba/Procurve switches.
Thanks