Log in to ask questions, share your expertise, or stay connected to content. Don’t have a login? Join now.
Hello
Is it possible to bond the interfaces on an AP-135 for ethernet redundancy, or to achieve over 1Gbps throughput?
So far it appears not, but I am looking for confirmation.
Thanks!
Honestly, the AP135 cannot negotiate WLAN rates to push more than a gig of WLAN traffic.
If the AP135 is plugged into 2 poe switches, it will take power from one. If the link on that interface goes down, the whole access point reboots and could be powered by the second switch. That would be like a two to three minute outage. Very few deploy in this manner.
© Copyright 2024 Hewlett Packard Enterprise Development LPAll Rights Reserved.