Wireless Access

 View Only
last person joined: yesterday 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

AP-93H eth1 - eth4 ports configuration

This thread has been viewed 0 times

  • 1.  AP-93H eth1 - eth4 ports configuration

    Posted Nov 04, 2013 05:38 PM

    I am having problems setting up the AP-93H eth1 - eth4 ports.  Does anyone have an example config for using access mode with a different vlan per port?  Are there any common gottcha's?

    Thanks!

    -BIll Davis



  • 2.  RE: AP-93H eth1 - eth4 ports configuration

    Posted Nov 04, 2013 05:50 PM

     

    Can you please share your config ?

     

    Make sure that the Wired AP is enabled and that the VLAN you are assigning exist in the controller.

     

    Re_ RAP - PC - DHCP - Airheads_2013-11-04_17-49-02.png

     

    You can confirm that the link is up by running the following command :

     

    show  ap debug port status ap-name <ap-name>

     

    You should also console into the AP to see if there's any errors