Original Message:
Sent: Jul 03, 2024 04:02 PM
From: schmelzle
Subject: AP mgmt-frame send request-beacon messages frequently
On AOS-8, show ap client trail-info <client-mac> is what you're looking for.
https://www.arubanetworks.com/techdocs/CLI-Bank/Content/aos8/sh-ap-clnt-trial.htm
Original Message:
Sent: Jul 03, 2024 06:19 AM
From: 宥呈 陳
Subject: AP mgmt-frame send request-beacon messages frequently
How should I inquire? Because when I check the user's roaming history, sometimes it takes 1 minute to change, sometimes it takes more than 10 minutes to switch, and it even takes him longer to switch.
Original Message:
Sent: Jul 02, 2024 12:28 PM
From: schmelzle
Subject: AP mgmt-frame send request-beacon messages frequently
As expected and indicated by the provided screenshots, the AP is sending beacon reports every 60 seconds to the 802.11k client. Is the client roaming every 60 seconds too?
Original Message:
Sent: Jun 28, 2024 05:54 AM
From: Will
Subject: AP mgmt-frame send request-beacon messages frequently
ArubaOS : 8.10.0.8
AP : 325,635
Client : win10
Client network : AX201,AX211
network driver : 23.40.0.4 2024/3/10
Question :
The user is connected normally and is in the same location without moving. However, the ap will keep sending physical layer messages, causing the user to change ap. If this state continues, the user will be disconnected.
show ap remote debug mgmt-frame ap-name 6FSW-006 client-mac f0:9e:4a:95:8e:e0
Controller setting :
| wlan virtual-ap vap-iot(md) |
| aaa-profile aaa-iot(md) |
| ssid-profile ssid-iot(md) |
| wmm-traffic-management-profile wmm(md) |
| no mobile-ip |
| vlan-mobility |
| band-steering |
| broadcast-filter all |
| dot11k-profile dot11k(md) |
| vlan 102 |
| deny-inter-user-traffic |
| ! |
| wlan dot11k-profile dot11k(md) |
| dot11k-enable |
| rrm-ie-profile rrm-ie(md) |
| ! |
| rf dot11a-radio-profile rf11a-default(md) |
| arm-profile arm11a-default(md) |
| max-tx-power 18 |
| min-tx-power 15 |
| ! |
|
|
|
| rf dot11g-radio-profile rf11g-default(md) |
| arm-profile arm11g-default(md) |
| max-tx-power 9 |
| min-tx-power 6 |
| interference-immunity 3 |
| ! |
|
| rf arm-profile arm11a-default(md) |
| cm-report-interval 5 |
| cm-sticky-min-signal 65 |
| ! |
|
|
|
|
|
| rf arm-profile arm11g-default(md) |
| no 80MHz-support |
| cm-report-interval 5 |
| cm-sticky-min-signal 65 |
| ! |