I am trying to configure a new AP in a LAN scenario on my controller and I am able to follow the wizard through but at step 10, I am unable to click on the tab that says CONFIGURE AP'S NOW.
I know that I am not ustilizing all of my AP licenses ( see below )
Total AP Licenses : 36
Remote-Node AP Licenses Used : 0
AP Licenses Used : 29
Tunneled Node Licenses Used : 0
Unused AP Licenses : 7
Licenses used for Campus AP's : 29
Available Campus AP's : 0
Licenses used for Remote AP's : 0
Available Remote AP's : 0
Total Ortronics AP Licenses : 0
Ortronics AP Licenses Used : 0
Total Indoor Mesh AP's Supported : 512
Indoor Mesh AP's Active : 0
Total Outdoor Mesh AP's supported : 512
Outdoor Mesh AP's Active : 0
Total RF Protect Licenses : 36
Remote-Node RF Protect Licenses Used : 0
RF Protect Licenses Used : 29
Total PEF Licenses : 68
Remote-Node PEF Licenses Used : 0
PEF Licenses Used : 29
Total 802.11n-120abg Licenses : 0
802.11n-120abg Licenses Used : 0
Total 802.11n-121abg Licenses : 0
802.11n-121abg Licenses Used : 0
Total 802.11n-124abg Licenses : 0
802.11n-124abg Licenses Used : 0
Total 802.11n-125abg Licenses : 0
802.11n-125abg Licenses Used : 0
Since it does not seem to be a license issue, anyone has any idea as to why I cannot add a new AP to any of my AP groups?
Thanks in advance for any contributions rendered.