Hi Everyone,
I'm a newbie in this field, apologies in advance.
I have an Aruba 6300M switch factory default settings.
What are the minimun steps to configure the switch to do a simple ping between two hosts connected to the 6300m?
I have only vlan 1 and all its interfaces in access mode. Soy when I ping from host A to host B works smoothly. But when I ping from host B to host A doesn't work.
I tried to configure an ip to interface vlan 1, and add the following command:
# ip route 0.0.0.0 0.0.0.0 <default router ip on vlan 1>
But still doesn't work.
What am I missing?
Thank you so much
Mariano