Wireless Access

 View Only
last person joined: yesterday 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

Aruba AP-315 after reset cannot access or setup Issue

This thread has been viewed 28 times

  • 1.  Aruba AP-315 after reset cannot access or setup Issue

    Posted Nov 10, 2023 08:22 AM

    My Aruba AP-315, after reset, cannot access or set up. Anyone can help pls.



  • 2.  RE: Aruba AP-315 after reset cannot access or setup Issue

    EMPLOYEE
    Posted Nov 11, 2023 12:42 AM

    is this a controller based AP or instant AP? and what firmware version are you running?



    ------------------------------
    If my post was useful accept solution and/or give kudos.
    Any opinions expressed here are solely my own and not necessarily that of HPE or Aruba.
    ------------------------------

    Original Message


  • 3.  RE: Aruba AP-315 after reset cannot access or setup Issue

    Posted Nov 13, 2023 02:34 AM

    Hello, thanks for replying. There is no controller based on the AP. The AP is connected to the POE switch to the network, but it also cannot show any SSID wifi channel to connect, so we cannot set the AP after resetting.

    I don't really know the firmware version.


    Original Message


  • 4.  RE: Aruba AP-315 after reset cannot access or setup Issue

    MVP
    Posted Nov 13, 2023 07:40 AM

    an Ap-315 requires a controller. An IAP-315 can operate as an Aruba Instant AP. If you have an Ap-315, it requires a controller to function.



    ------------------------------
    Bruce Osborne ACCP ACMP
    Liberty University

    The views expressed here are my personal views and not those of my employer
    ------------------------------

    Original Message


  • 5.  RE: Aruba AP-315 after reset cannot access or setup Issue

    EMPLOYEE
    Posted Nov 14, 2023 12:03 AM

    thats right, look at the sticker at the back of the AP and it should say either AP-315 or IAP-315.

    if it is AP-315, then you need to have a controller.



    ------------------------------
    If my post was useful accept solution and/or give kudos.
    Any opinions expressed here are solely my own and not necessarily that of HPE or Aruba.
    ------------------------------

    Original Message


  • 6.  RE: Aruba AP-315 after reset cannot access or setup Issue

    Posted Nov 14, 2023 02:17 AM

    It should be a IAP-315-RW.


    Original Message


  • 7.  RE: Aruba AP-315 after reset cannot access or setup Issue

    Posted Nov 14, 2023 02:16 AM

    the label remark as IAP-315_RW. I think it should be a IAP.


    Original Message


  • 8.  RE: Aruba AP-315 after reset cannot access or setup Issue

    EMPLOYEE
    Posted Nov 14, 2023 08:39 AM

    What behavior are you seeing from the IAP?  If you've performed a reset using the reset button then the IAP, assuming no other IAP is operating in the VLAN, should come up with default configuration and be broadcasting the SetMeUp SSID.  You should also be able to SSH to the IAP at whatever IP address is pulled by DHCP.



    ------------------------------
    Carson Hulcher, ACEX#110
    ------------------------------

    Original Message