ip helper-address command did not appear in int vlan ***6000(config)# int vlan 106000(config-if-vlan)# ip helper-address ***.***.4.2Invalid input: helper-address
Do you have firmware10.10.x on the 6000s?
no its 10.8
ok then upgrade to that version also note that 10.08 is end of support
For those with the same problem, you can use the Aruba Switch Feature Navigator, and then when you search under L3 features for DHCP relay, you will find that that feature was introduced in 10.02.0002. The point that 10.08 is end of support is a separate point, relevant for other reasons as you probably want to run supported software version.
© Copyright 2023 Hewlett Packard Enterprise Development LPAll Rights Reserved.