Hello All,
I'm reaching out for a simple configuration question. I just opened my first 3810M box and have started to configure it.
I'm struggling to figure out how to assign an IP address to an interface.
I'm connecting a trio of switches in a very simple network.
MDF Switch 1: (172.16.1.1) /16
MDF Switch 2: (172.16.2.1) /16
MDF Switch 3: (172.16.3.1) /16
Each of those systems have their own set of networks within their sites which should be covered by OSPF.
ip routing
router ospf
area backbone range 10.0.0.0 255.0.0.0 type summary
area backbone range 172.16.0.0 255.255.0.0 type summary
area backbone range 192.168.0.0 255.255.0.0 type summary
enable
exit
With my previous Cisco switches I simply took an interface and performed:
interface GigabitEthernet0/1
description [###]---> Uplink to 172.16.1.1 <---[###]
no switchport
ip address 172.16.2.1 255.255.0.0
How can I assign a interface/port on this 3810M to be a L3 port to accept an IP in order to inter-connect my MDFs?
Or am I headed in the wrong direction to inter-connect the MDFs?
#3810#ip#routing