a good idea it is also to always close the session for avoid this issue :)
------------------------------
PowerArubaSW : Powershell Module to use Aruba Switch API for Vlan, VlanPorts, LACP, LLDP...
PowerArubaCP: Powershell Module to use ClearPass API (create NAD, Guest...)
PowerArubaCL: Powershell Module to use Aruba Central
PowerArubaCX: Powershell Module to use ArubaCX API (get interface/vlan/ports info)..
ACEP / ACMX #107 / ACDX #1281
------------------------------
Original Message:
Sent: Oct 13, 2023 07:35 AM
From: andre.henkel@prowin.net
Subject: ArubaOS Switch - Error 503 - too many REST sessions
Thanks for this solution which worked fine for me!
But my error was bit different so I'm going to add it here:
Switch: 2x Aruba 3810M-24G-1-slot Switch (JL071A) in a stack
Firmware. KB.16.11.0008
I've disabled and re-enable the webinterface with these commands:
no web-managementweb-management
After this the web management was unaccessible even after rebooting - the error was always:
503 Service Unavailable The server is currently busy. Please try again later
But the hint was the message when disableling the web management:
So I've resetted the REST interface with your commands
no rest-interfacerest-interface
and the web interface was immediatly fine.
So thanks again!
Original Message:
Sent: Oct 29, 2018 12:08 PM
From: legall
Subject: ArubaOS Switch - Error 503 - too many REST sessions
Hi,
The sessions limit is set to 5 simultaneous sessions, and it can't be changed.
In order to reset your sessions on the switch, you can do a :
1. no rest-interface
2. rest-interface
Resetting the Rest Interface will also reset your REST sessions.
Or as you said, you call also play with the session timeout.