Wireless Access

 View Only
last person joined: 11 hours ago 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

Autonomous Setup, MSM430 won't pass data

This thread has been viewed 0 times

  • 1.  Autonomous Setup, MSM430 won't pass data

    Posted Feb 08, 2012 01:21 PM

    I have a new MSM430 that I'm setting up.  I don't have a controller, so I set it to autonomous mode.  I created a VSC to use both radios, WPA2 protection (no radius server), updated to the latest firmware.  My laptop see's and correctly logs into the AP, but no traffic is passed between the two.  I can't access the internet or the company servers.  The online help files are pretty good, but I can't figure out what else would need to be set up.  Do I need to create a VLAN doc?

    I did change one setting yesterday that got it working (don't remember what), but then I was totally locked out of the management interface, so I had to reset it and start again from scratch.

    Can anyone point me in the right direction?


    #msm430
    #autonomous


  • 2.  RE: Autonomous Setup, MSM430 won't pass data

    Posted Feb 08, 2012 02:59 PM

    Bottom left of VSC settings, "Wireless security filters" should be unchecked. That's what messed me up my first time. 



  • 3.  RE: Autonomous Setup, MSM430 won't pass data

    Posted Feb 08, 2012 03:21 PM

    That did it!

     

    Thanks,

     

     



  • 4.  RE: Autonomous Setup, MSM430 won't pass data

    Posted Feb 08, 2012 04:32 PM
    glad to hear it :)


  • 5.  RE: Autonomous Setup, MSM430 won't pass data

    Posted Feb 13, 2012 02:23 PM

    TSCHAPS.

     

    Would you mind contacting me offline?   jrink@sourceonetechnology.com

     

    Much appreciated.

    J