Wired Intelligent Edge

 View Only
last person joined: 23 hours ago 

Bring performance and reliability to your network with the HPE Aruba Networking Core, Aggregation, and Access layer switches. Discuss the latest features and functionality of your switching devices, and find ways to improve security across your network to bring together a mobile-first solution
Back to discussions
Expand all | Collapse all

Cannot Ping Subnets on HP Procurve 2510/v1910

This thread has been viewed 0 times

  • 1.  Cannot Ping Subnets on HP Procurve 2510/v1910

    Posted Dec 10, 2011 07:04 PM

    We are trying to setup three new switches and are having some difficulties when it comes to our overall WAN setup.

     

    The switches function fine for the branch they are setup for but when trying to access or even ping the switches over the WAN from a different subnet we get no response.

     

    The Procurve 2510 does not seem to have any routing capabilities so that's the one I'm most concerened about. Is there a setting or something I'm missing that would enable other subnets on the network to simply ping the switch? When it comes to the v1910s, I think I have that fixed by creaing a static route for 0.0.0.0 to the Default Gateway in that branch, would that be correct?

     

    Can anyone offer some insight?

     

     

    P.S. This thread has been moevd from Switches, Hubs, Modems (Legacy ITRC forum) to ProCurve / ProVision-Based. - Hp Forum Moderator


    #subnet
    #ping
    #Pinging
    #WAN
    #switches


  • 2.  RE: Cannot Ping Subnets on HP Procurve 2510/v1910

    Posted Dec 11, 2011 10:17 PM

    The 2510 switches do not do layer 3 routing, however if all you are trying to access is the management IP address of the switch then just make sure that the default gateway on the switch is set to the sites local router IP address (same as if it were a PC or server).

    You can do this either via the web interface or via the CLI

     

    config

    ip default-gateway xx.xx.xx.xx

    write memory

     

     



  • 3.  RE: Cannot Ping Subnets on HP Procurve 2510/v1910

    Posted Jul 04, 2013 04:52 AM

    Hi - my situation - I am sitting on 192.168.1.0/24

    2 HP 2910 Al4G switches sitting on 192.168.3.0/24

     

    HP Switch 1 Default VLAN1 IP:

    192.168.3.3

    Subnet Mask: 255.255.255.0

    Default Gateway: 192.168.3.3

     

    HP Switch 2 Default VLAN1 IP:

    192.168.3.4

    Subnet Mask: 255.255.255.0

    Default Gateway: 192.168.3.3

     

    I can access any other device on the 192.168.3.x network using its access protocol (HTTP, PING, SNMP, Telnet) from the 192.168.1.x network.

     

    I cannot access the management console of my switches via HTTP or Telnet from the 192.168.1.x network.

    The only way I can access the switches is from a device/host located on the 192.168.3.x network using either HTTP or Telnet to either switches IP address.

     

    Can anyone explain why? Thanks in advance



  • 4.  RE: Cannot Ping Subnets on HP Procurve 2510/v1910

    Posted Mar 17, 2014 03:34 AM

    Hi did you ever manage to find out what the solution was to access the other switch network over the WAN?