Weird thing is happening to me... I have an AP in a remote site which i am trying to provision. It is connected to a cisco switch. I see the AP is getting an IP , there is an ARP entry and I can see the MAC ADD in the table on when I configure the port as access mode.
interface FastEthernet1/0/44
description NAT1-WLAN105-01
switchport access vlan 64
switchport mode access
no logging event link-status
no snmp trap link-status
spanning-tree portfast
end
Internet 10.27.91.133 14 d8c7.c8ca.249d ARPA Vlan64
I cannot ping the AP
CORP3750-01#ping 10.27.91.133
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 10.27.91.133, timeout is 2 seconds:
.....
Success rate is 0 percent (0/5)
I can't see why or how this is possible.
Any Ideas anyone?
thanks,