Thank you, I tried this and it works.
It works like this: When an AP has every SSID enabled is has the parameter "zonename": "_#ALL#_"
To only enable some SSIDs "zonename" needs to contain a string of comma-seperated SSID names. For example: "zonename": "WiFi01,Guest01"
You can read and set this by calling
/configuration/v2/ap_settings/{serial}
I noticed that you need to send all parameters in the body when using this API endpoint. So you need to call GET to get all current parameters, then you can change "zonename" to the value you need and write it by sending POST
------------------------------
Thanks,
Bjarne
------------------------------
Original Message:
Sent: Jan 23, 2023 03:46 AM
From: cordless
Subject: Central API - AOS10 - Disable SSID on single AP
You can use APIs to get this done - You can use the AP Zone functionality from 8.x to specify which SSIDs are mapped to an 10.x AP.
Original Message:
Sent: Jan 19, 2023 02:14 PM
From: bkohnke
Subject: Central API - AOS10 - Disable SSID on single AP
Hi all,
I am looking for a way to disable a single SSID on a single AP via the API.
I was looking through the AP configuration endpoints but all I could find is how to disable the whole band.
https://developer.arubanetworks.com/aruba-central/reference/apiap_settingsupdate_ap_settings_v2
On the UI this is possible by editing the AP and then going to WLANs
Does anyone know the API endpoint where I can configure that?
------------------------------
Thanks,
Bjarne
------------------------------