Comware

 View Only
last person joined: 2 days ago 

Back to discussions
Expand all | Collapse all

check interface block with stp via centreon

This thread has been viewed 0 times

  • 1.  check interface block with stp via centreon

    Posted Dec 05, 2018 07:20 AM

    Hello,
    I configure on hp5130b switch from the stp



    conf:

     

    stp mode mstp

stp region-configuration
region-name
revision-level 1
instance 1 vlan 1 to 199
instance 2 vlan 200 to 399
active region-configuration
stp instance 0 to 3 priority 12288
stp bpdu-protection
loopback-detection interval-time 5
shutdown-interval 0
    interface range GigabitEthernet 1/0/1 to GigabitEthernet 1/0/48
stp edged-port
stp global enable

    to check if a port and block I use the command:

    display stp down-port


    I wanted to know if with my centreon-plugin monitoring tool if it was possible to check the interface block ?

    thank you

     

     


    #checkinterface
    #centreon-plugin
    #STP
    #spanning-tree


  • 2.  RE: check interface block with stp via centreon

    EMPLOYEE
    Posted Dec 10, 2018 03:36 AM

    Hi There,

     

    HPE Switches usually does send these traps and shows the port status w.r.t STP in some of the commonly used NMS tools such as IMC and Solardwinds.

    Not sure centreon-plugin monitoring tool, but if you are using the appropriate MIBs in the monitoring tool, then you should be getting it.