Hi all,
I'm new to the ARUBA world and to the use of the CLI. I have a 6300 with firmware FL.10.08.1021. I have created the following config on a specific port
interface 1/1/23
no shutdown
rate-limit unknown-unicast 50000 kbps
rate-limit broadcast 50000 kbps
description DAC link to ground floor stack port 1/1/52
no routing
vlan trunk native 1
vlan trunk allowed 225,242,252,2242,2257,3046,3409
arp inspection trust
dhcpv4-snooping trust
exit
At the end of this is the word 'exit' - I'm not quite sure how it got there but its likely I have a cut and paste episode. But it shouldn't be there.
My question is how do I get rid of the offending statement? I've tried # configure interface 1/1/23 > no exit - the response to this is 'Invalid input: exit'.
I'm quite happy to flush all the config details for that interface but I'm not aware of a command that will do that. I would also note that when I back up the switch config via SFTP 'exit' does not appear in the config file??? Odd...
Any ideas?
Regards,
Andrew
------------------------------
Andrew Gerrard
------------------------------