I would like to configure switches in order to plug Cisco phones (7841 for ex) using only LLDP MED without knowing the mac address of phones. I have tried but I have to put the line below in order to make phones working.
# voice vlan mac-address xxxx-xxxx-xxxx mask ffff-ff00-0000 description Phones
Hello @AntonyZEL !
AFAIK you need that command, but if your target is to avoid MAC address administration burden you may use two general records that will cover all Cisco phones:
voice vlan mac-address 0000-0000-0000 mask ff00-0000-0000voice vlan mac-address 8000-0000-0000 mask ff00-0000-0000
Hope this helps!
Hi @AntonyZEL !
I'm afraid I forgot to ask you the most important question - what is the switch model? I need to know if it's running Comware 5 or 7 as configuration is quite different...
© Copyright 2023 Hewlett Packard Enterprise Development LPAll Rights Reserved.