Wireless Access

 View Only
last person joined: 21 hours ago 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

Controller Running 8.6 code

This thread has been viewed 23 times

  • 1.  Controller Running 8.6 code

    Posted Sep 18, 2023 04:05 PM

    I have 2 controllers with 8.6 code that I need to join to a Mobility Conductor running 8.10.  Is this possible?  I know you can have the controllers running a lower code than Mobility Conductor.  The controllers are remote, so I do not have the ability to upgrade them to 8.10 until they are joined to the Mobility Conductor.  Please advise.



    ------------------------------
    Peter
    ------------------------------


  • 2.  RE: Controller Running 8.6 code
    Best Answer

    EMPLOYEE
    Posted Sep 18, 2023 07:15 PM

    the feature is called multi-version and i think it should be fine.

    Here is the user guide reference for Mobility conductor with 8.10.



    ------------------------------
    If my post was useful accept solution and/or give kudos.
    Any opinions expressed here are solely my own and not necessarily that of HPE or Aruba.
    ------------------------------

    Original Message


  • 3.  RE: Controller Running 8.6 code

    Posted Sep 19, 2023 06:05 AM

    Thank you!



    ------------------------------
    Peter
    ------------------------------

    Original Message


  • 4.  RE: Controller Running 8.6 code

    EMPLOYEE
    Posted Sep 18, 2023 09:29 PM

    There may be a logged warning about version mismatch but the association should go fine.  8.10 on a Conductor is specifically called out as having multi-version support down to MDs running 8.6.



    ------------------------------
    Carson Hulcher, ACEX#110
    ------------------------------

    Original Message


  • 5.  RE: Controller Running 8.6 code

    MVP EXPERT
    Posted Sep 20, 2023 09:26 AM

    I migrate some customers from 8.6.x.x to 8.10.x.x without any issues.

    • First update the Mobility Conductor
    • Second update your Managed Devices (gateways).

    Create VMware snapshot and configuration of the Mobility Conductor before you start.



    ------------------------------
    Marcel Koedijk | MVP Expert 2023 | ACEP | ACMP | ACCP | ACDP | Ekahau ECSE | Not an HPE Employee | Opinions are my own
    ------------------------------

    Original Message