You go to System view with command "system"
then you can add default gateway with
"ip route-static 0.0.0.0 0 <default gw ip>"
Lp, Gorazd
------------------------------
Gorazd Kikelj
MVP Guru 2024
------------------------------
Original Message:
Sent: Mar 12, 2024 10:07 AM
From: AlwaysBestToAsk
Subject: Correct command to set Gateway on HP 5130 JG941a Switch
Hi all,
Hopefully i've got this in the correct forum but i've got a couple of HP JG941A 5130 switches at a remote location that i can't manage remotely due to them not having a gateway set on them so i've connected via console but i cannot find the correct command to get into any kind of enable or config mode to allow me to enter the ip default gateway command that i keep seeing to add the gateway.
Can anyone tell me what the correct syntax is to firstly get into the correct command level on these and then should i then be able to use the ip default gateway command or is it a different command on these models ?
Thanks in advance.