Probably yes.
------------------------------
Herman Robers
------------------------
If you have urgent issues, always contact your Aruba partner, distributor, or Aruba TAC Support. Check
https://www.arubanetworks.com/support-services/contact-support/ for how to contact Aruba TAC. Any opinions expressed here are solely my own and not necessarily that of Hewlett Packard Enterprise or Aruba Networks.
In case your problem is solved, please invest the time to post a follow-up with the information on how you solved it. Others can benefit from that.
------------------------------
Original Message:
Sent: Mar 28, 2023 08:03 PM
From: phongshader
Subject: enable switch connection to Aruba Central through cli?
Hmmm, Central was disabled through the WebUI...would the cli commands still work?
Original Message:
Sent: Mar 28, 2023 03:35 AM
From: Herman Robers
Subject: enable switch connection to Aruba Central through cli?
It depends on how you disabled Central for these switches:
------------------------------
Herman Robers
------------------------
If you have urgent issues, always contact your Aruba partner, distributor, or Aruba TAC Support. Check https://www.arubanetworks.com/support-services/contact-support/ for how to contact Aruba TAC. Any opinions expressed here are solely my own and not necessarily that of Hewlett Packard Enterprise or Aruba Networks.
In case your problem is solved, please invest the time to post a follow-up with the information on how you solved it. Others can benefit from that.
Original Message:
Sent: Mar 21, 2023 03:56 PM
From: phongshader
Subject: enable switch connection to Aruba Central through cli?
We have a stack of 3 3810m switches that were connected to Aruba Central but we disconnected them because it was easier to manage them through the web ui. However we've run into an issue, about a month ago, that whenever we try to connect through the web ui it reboots the 1st switch in the stack. Is there a way to re enable the connection to Aruba Central through cli?