10.14 is really new; I didn't even know it was released. Reporting to TAC is indeed the best to do at this moment, as if there is an actual problem, they can pull back the release.
It may also be that there is more thorough testing in 10.14 that now finds an issue with the power supply unit (PSU), that was not checked/tested before. TAC will probably tell you more, please update here if you have more information.
------------------------------
Herman Robers
------------------------
If you have urgent issues, always contact your Aruba partner, distributor, or Aruba TAC Support. Check
https://www.arubanetworks.com/support-services/contact-support/ for how to contact Aruba TAC. Any opinions expressed here are solely my own and not necessarily that of Hewlett Packard Enterprise or Aruba Networks.
In case your problem is solved, please invest the time to post a follow-up with the information on how you solved it. Others can benefit from that.
------------------------------
Original Message:
Sent: May 31, 2024 08:04 AM
From: NetTux
Subject: Firmware bug in 10.14 for CX 6000?
While testing the latest 10.14 firmware I discovered a strange behaviour. The switch starts normally and does its job, but the error LED flashes. A look into the log showed:
PSU 1/1 changed state to OK
after a few seconds/minutes
PSU 1/1 changed state to WARNING
Then I restarted it, but the same result.
So I rebooted with the old 10.13.1020 firmware.
It has been running for hours without any errors. I therefore suspect a software bug. To be on the safe side, I reported this to customer service. Have any of you seen anything like this?