Comware

 View Only
last person joined: 2 days ago 

Back to discussions
Expand all | Collapse all

HP 1810-24G will not reset

This thread has been viewed 0 times

  • 1.  HP 1810-24G will not reset

    Posted Feb 22, 2013 01:24 PM

    I was attempting to setup link aggregation with a Synology RS812 NAS and the switch froze. I've attempted (multiple times) to reset the switch to factor defaults by:

     

    • Holding down the "Reset" and "Clear" on the front panel
    • Releasing "Reset"
    • Releasing "Clear" after the LED Mode lights flash twice

     

    The switch will not come up completely. Fault indicator is flashing and ports 9-16 have the link light blinking. This configuration implies fault other than self-test. This says configuration fault to me, but I thought I was following the instructions to reset to factory defaults above.

     

    Ideas?

     

     

    P.S. This thread has been moved from ProCurve / ProVision-Based to Web and Unmanaged - HP Forum Moderator

     

     

     


    #reset
    #hp1810


  • 2.  RE: HP 1810-24G will not reset

    Posted Feb 22, 2013 02:41 PM

    Well I submitted a ticket to HP, within 30 minutes I had a phone call and a new switch on it's way for overnight delivery. No arguments.

     

    All I can say is that this kind of service will keep me coming back to HPs Procurve networking gear.

     

    Rare that you get that kind of service these days, at least in my experience.