Hello
lovalim,
This is the default basic CLi mode of the 1950 as outlined in the user guide starting page 138:
Commands are available for you to perform basic device management when the Web interface is not
available.
To manage the device from the CLI, access the device through the console port or Telnet. You are
placed in user view immediately after you log in to the CLI.
Table 22 provides a command summary. All these commands are available in user view. However,
the commands you can use depend on the user roles you have. By default, a command is available
for the predefined user roles. You can use the RBAC feature to assign a command to additional user
roles from the Web interface.
https://www.hpe.com/psnow/doc/c04657809Hope this helps!
------------------------------
-Alex-
------------------------------
Original Message:
Sent: Jul 03, 2022 02:23 AM
From: Hussain sabun
Subject: HP 1950