Comware

 View Only
last person joined: 2 days ago 

Back to discussions
Expand all | Collapse all

HP Comware Lab L2VPN Support

This thread has been viewed 3 times

  • 1.  HP Comware Lab L2VPN Support

    Posted Jun 08, 2015 04:07 PM

    Any idea whether the new HP Comware Lab (7.1.59) supports L2VPN?

    I'm asking as I'm pretty sure that the previous version didn't.

     

    Regards,

     

    Peter



  • 2.  RE: HP Comware Lab L2VPN Support

    EMPLOYEE
    Posted Jun 10, 2015 10:19 AM

    Hello Peter,

     

    7.1.59 does not. You can configure it, but no traffic seems to go through (e.g. after sending a ping one side shows the partners MAC in ARP table, other side does not, seems like unidirectional traffic?).

    Same for VPLS.

     

    Best regards,

    Ingo



  • 3.  RE: HP Comware Lab L2VPN Support

    EMPLOYEE
    Posted Mar 16, 2017 08:00 AM

    Hello,

    To my experience MPLS L2VPN as well as VXLAN/EVPN do not work with bridged-ports in the simulator; can be configured but traffic is not flowing. However they work perfectly using a routed port towards the end-node.

    Try for having traffic untagged / access port:
    interface GigabitEthernet1/0/1
    port link-mode route
    xconnect vsi <VSI-Name>

    Example adding a tagged VLAN; use a sub interface:
    interface GigabitEthernet1/0/1.10
    vlan-type dot1q vid 10
    xconnect vsi <VSI-Name>

    Best use a router manual for reference on the setup, i.e. VSR1000 manuals.

    Regards,
    Ingo