Wired Intelligent Edge

 View Only
last person joined: 21 hours ago 

Bring performance and reliability to your network with the HPE Aruba Networking Core, Aggregation, and Access layer switches. Discuss the latest features and functionality of your switching devices, and find ways to improve security across your network to bring together a mobile-first solution
Back to discussions
Expand all | Collapse all

HP TOPTOOL and ARP CACHE

This thread has been viewed 1 times

  • 1.  HP TOPTOOL and ARP CACHE

    Posted Feb 18, 2003 03:27 PM

    How is it possible to get the arp cache of a procurve 4000 to find a specific IP adddress matching a MAC address with HP TOPTOOLS ???
    #toptools


  • 2.  RE: HP TOPTOOL and ARP CACHE

    Posted Feb 18, 2003 04:41 PM
    I've never used Toptools but the manual says you can get IP and MAC info from the Node Port Table. Devices/Device Types/Networking Types Then right click on Networking Types and selecting Node Port Table.

    See Page 6-7 in the TopTools User manual

    http://www.hp.com/rnd/support/manuals/toptools_hubs_switches.htm

    Ron


  • 3.  RE: HP TOPTOOL and ARP CACHE

    Posted Feb 18, 2003 04:54 PM
    Thx for your answer but it's ok for us only vhen a port is connected to another HP Procurve but it's bad when the port is connected to an end node workstation.

    Maybe it's because of our config.


    Thanks again.


    Jean-Luc Largeau


  • 4.  RE: HP TOPTOOL and ARP CACHE

    Posted Feb 19, 2003 09:58 AM
    Sounds like you do not have Discovery turned on. See Chapter 4 on Discovery. You may have to tell it about the subnetworks but it sounds like it should find all of the hosts on your network. It may take a while. Make sure you have Ping Discovery checked. (Fig 4-3)


    Ron


  • 5.  RE: HP TOPTOOL and ARP CACHE

    Posted Feb 19, 2003 10:13 AM
    Thanks,

    It's ok now !