Hi All,
I have been playing around with an IAP-VPN setup that i have simulated in my lab.
Apparently i can see the output of "show vpn status" IAP as established to the controller.
Also i can see "show crypto isakmp sa" and "show crypto ipsec sa" on the controller as well.
But i cannot see any output on the "show iap table" command on the controller.
(POC-VPNC) [mynode] (config) #show crypto isakmp sa
ISAKMP SA Active Session Information
------------------------------------
Initiator IP Responder IP Flags Start Time Private IP
------------ ------------ ----- --------------- ----------
10.76.147.163 10.76.147.131 r-v2-c-I Dec 21 08:38:19 172.18.0.1
(POC-VPNC) [mynode] (config) #show crypto ipsec sa
IPSEC SA (V2) Active Session Information
-----------------------------------
Initiator IP Responder IP SPI(IN/OUT) Flags Start Time Inner IP
------------ ------------ ---------------- ----- --------------- --------
10.76.147.163 10.76.147.131 5d0d8c00/f6761a00 UT2 Dec 21 10:22:28 172.18.0.1
(POC-VPNC) [mynode] (config) #show iap table
Trusted Branch Validation: Disabled
IAP Branch Table
----------------
Name VC MAC Address Status Inner IP Assigned Subnet Assigned Vlan
---- -------------- ------ -------- --------------- -------------
Total No of UP Branches : 0
Total No of DOWN Branches : 0
What could i be missing ?