Thanks for the reply, these switches are purely all access layer.
Since posting this question I have been reading and also consulted our HP
Aruba vendor for a bit of advise.
I was getting mixed up with the term 'stacked'. My assumption was that all
three would act as one single unit as I have done in the past with a
variety of switching kit.
But I guess that specific setup isn't so important really and I've now read
about meshing and have used the 8 port 10Gb modules that are available to
connect each switch chassis. The mesh topology is working and we are now
moving forward with setting up VLAN's and configuring ports.
Thanks very much
--
Grant Cassin :: +44 (0) 7508 053 824