I'm searching for a deployment guide on a PTP setup. I need to extend my network using a PTP bridge (i think). I found some old info for AOS6, but nothing new for AOS8.
Any info is appreciated. Below is the old documentation.
there are a lot of guides to find.https://community.arubanetworks.com/discussion/howto-point-to-point-mesh-on-aos-85
This information has been very helpful, thank you. But I think i'm stuck here. I can get the AP's to mesh, and in the controller I see both AP's online. The far ap (.91) is seen as up on my controller. But, when I try to configure and ping the managment interface on my far switch 68.3, i'm unable to ping the interface. I think my config on the Wired AP Profile is incorrect. Please advise.
VLAN 68 is switch Management
VLAN496 is AP VLAN
Switch port interface config:
Interface where AP's .90 and .91 are connected
Mobile1 switch 10.0.68.2
interface 8 name "10.110.96.90" power-over-ethernet critical poe-allocate-by class tagged vlan 68,496 device-type network-device
Mobile 2 switch 10.0.68.3
interface 8 name "AP 10.110.96.91" power-over-ethernet critical poe-allocate-by class tagged vlan 68,496 device-type network-device
I think you need to change the forward mode on your wired AP profile to tunneled to cross the mesh.
© Copyright 2023 Hewlett Packard Enterprise Development LPAll Rights Reserved.