Comware

 View Only
last person joined: 2 days ago 

Back to discussions
Expand all | Collapse all

Port address translation on JG732A

This thread has been viewed 0 times

  • 1.  Port address translation on JG732A

    Posted Jun 04, 2019 07:21 AM

    Hi, on a Cisco PIX I had a config where the WAN port was 1xx.1x.253.10 and the LAN subnet was 1xx.1xx.68.0/24 - a public IP range.

    I had PAT setup so that I could open and close ports for the LAN subnet. By default all incoming ports were closed. If I opened the RDP port then RDP could be used from the WAN to connect to all of the machines on the 68 subnet. Similarly if I opened the SSH port, from the WAN I could SSH to any machine on the 68 subnet.

    How do I set this up on a MSR1003-8?


    #pat
    #firewall
    #publicIP


  • 2.  RE: Port address translation on JG732A

    EMPLOYEE
    Posted Jun 19, 2019 11:16 AM

    Hi,

    Please use the below link and follow the guide to configure NAPT (PAT) on MSR1003-8 router.

    https://www.manualshelf.com/manual/hp/hp-msr1003-8-ac-router/r2511-hp-msr-router-series-layer-3-ip-services-configuration-guidev5/page-8.html

     

    I am an HPE Employee